Add Lamp

The only brightness.

Unless you want your map to be a dark, intimidating map, it might be wise to add some lights into your map.

Click anywhere on the grid to add your light(s).

The default power setting for the light is 0.4.

"Flare" = If the light can be "seen" or not. If there is no flare, there will be lighting only in the area.

To make a light "indestructible", add an invisible door around the light, but be sure it cannot be penetrated by bullets.

The number of lights in a map determines how long it'll take for the map to load.

If you make the flare input a negative number, the light will appear, but the area is dark. :D

Since it's 2020 era, most people won't accept the light with the flashes which would blind people eyes. So it's better to treat it as a "light source", which you can use decoration as the light emitter.

If you are planning to do a shadowmap of 9999, don't waste your time and flash resources to add lamp.